CAT High Interlock to Low Interlock

CAT High Interlock to Low Interlock manual.

For anybody trying to go from a high interlock number to a low interlock number while flashing a CAT, there
is a solution without using the high interlock factory password generator. It is a workaround where you flash
a file to the truck and program like normal and THEN flash the file you want to the truck.

To Flash A Caterpillar Engine From A High Interlock File To A Low
Interlock File
1)  Locate the file (or equivalent file) that is currently on the ECM in your collection;
copy and paste this file to a location that is easy to find if you should have to
return the ECM to its original flash.
2)  Locate the flash file that the driver wants installed to the truck and copy and paste
this file into the same location as the original file.  Memorize or write down which
is the original and which is the new one.
     3)  Determine whether the ECM on the truck is a 40-pin or 70-pin.  
3a) If the ECM is a 40-pin, locate flash file# 125-8005.  Copy and
      paste this file into the same location as the first two files.
3b) If the ECM is a 70-pin, locate flash file# 177-7013.  Copy and
       paste this file into the same location as the first two files.
4)  Open the WinFlash utility in CAT ET.  Depending on if your ECM is a 40-pin or
70-pin, select either flash file# 125-8005 or 177-7013 and click “Begin Flash.”
5)  Once the flash is completed successfully and WinFlash displays the dialogue box
saying so, click “Return to CAT ET.”  Navigate to the “Configuration” screen and
scroll down to “System Settings.”  The value box next to “Personality Module
Code” should say “NOT PROGRAMMED.”  Double click this box and you will
be prompted with a dialogue box asking if you are sure you want to program this
parameter.  Click yes and another dialogue box will appear asking you to enter
Factory passwords.  Continue as you would normally; entering the factory
passwords (HIGH INTERLOCK PASSWORDS NOT REQUIRED) into their
respective blanks and clicking “Okay.” After a brief pause, the Personality
Module Code should program to an interlock under 300.
6)  Once this is complete and the Personality Module Code is successfully
programmed, navigate back into WinFlash.
7)  Now, select the file that you located in step 2 and click “Begin Flash.”
8)  Once the flash is completed successfully and WinFlash displays the dialogue box
saying so, click “Return to CAT ET.”  Navigate to the “Configuration” screen and scroll down to “System Settings.”  The value box next to “Personality Module
Code” should say “NOT PROGRAMMED.”  Double click this box and you will
be prompted with a dialogue box asking if you are sure you want to program this
parameter.  Click yes and another dialogue box will appear asking you to enter
Factory passwords.  Continue as you would normally; entering the factory
passwords (HIGH INTERLOCK PASSWORDS NOT REQUIRED) into their
respective blanks and clicking “Okay.” After a brief pause, the Personality
Module Code should program to the interlock code for the file you selected in
step 2.
9)  In the configuration screen, navigate to the “Selected Engine Rating” parameter
group and expand it.  Double click in the value box next to “Rating Number”.
Make sure that the rating desired is selected as the current rating.  If it is not,
select the rating you want and click “Okay.”
The truck should now be programmed and you will have avoided the
need for a “HIGH INTERLOCK FACTORY PASSWORD.”